Facebook Official Page
Share EAGLE library
Have you created EAGLE library?
Did you find an interesting library?
Why not share with the community?
DIY Modules Eagle Library version 1.7.0 has been released.
DIY Modules Eagle Library version 1.6.0 has been released.
Have you created, modified or found an interesting EAGLE library? Why not share with the community? Now you can add EAGLE libraries to our catalogue.
Click here and check it out!
Search for EAGLE Library
ESP8266 7 SEGMENT ARDUINO TO252 RELAY MURATA LM3886 LM2596 LCD JST 315 MHZ PCB ANTENNA 1N4007 TL431 MOLEX HIROSE USB CAPACITOR 433 MHZ ARDUINO NANO POTENTIOMETER CONNECTOR TDA VISHAY LED ATMEGA SWITCH
Ohter interesting searches:
CY8C IR2110 ACDC 7805 RCA TERMINAL BLOCK BATTERY DIODE TRANSISTOR CONN INV USB TYPE C POLOLU ACS712 RASPBERRY BF INDUCTOR STM32F4 NRF24L01 IRF BME280 CONNECTOR USB 3.0 CAPACITOR CERAMIC BLUETOOTH NRF24L01 FUSE ATMEL
EAGLE Library Object
|Uploaded by:||Juergen Messerer|
|Remarks:||This library is a part of the archive file m-pad-2.1.zip|
Show other files in the archive
|Download options:||Download whole archive|
( 303.9 KiB )Download original file
( 1,153.0 KiB )Download file converted
to the latest EAGLE format
( 2,969.6 KiB )
|Description:||MEMSIC's MXD2125 G/H M/N|
FEATURES: Resolution better than 1 milli-g Dual axis accelerometer fabricated on a monolithic CMOS IC On chip mixed mode signal processing No moving parts 50,000 g shock survival rating 17 Hz bandwidth expandable to >160 Hz 3.0V to 5.25V single supply continuous operation Continuous self test Independent axis programmability (special order) Compensated for Sensitivity over temperature Ultra low initial Zero-g Offset
Automotive: Vehicle Security/Vehicle stability control/ Headlight Angle Control/Tilt Sensing
Security: Gas Line/Elevator/Fatigue Sensing
Information Appliances Computer Peripherals/PDA?s/Mouse Smart Pens/Cell Phones
Gaming: Joystick/RF Interface/Menu Selection/Tilt Sensing
GPS: electronic Compass tilt Correction
Consumer: LCD projectors, pedometers, blood pressure Monitor, digital cameras
The MXD2125G/H/M/N is a low cost, dual axis accelerometer fabricated on a standard, submicron CMOS
process. It is a complete sensing system with on-chip mixed mode signal processing. The MXD2125G/H/M/N
measures acceleration with a full-scale range of ±3 g and a sensitivity of 12.5%/g @5V at 25°C. It can measure both
dynamic acceleration (e.g. vibration) and static acceleration (e.g. gravity).
The MXD2125G/H/M/N design is based on heat convection and requires no solid proof mass.
This eliminates stiction and particle problems associated with competitive devices and provides shock survival of 50,000
g, leading to significantly lower failure rate and lower loss due to handling during assembly.
The MXD2125G/H/M/N provides two digital outputs that are set to 50% duty cycle at zero g acceleration.
The outputs are digital with duty cycles (ratio of pulse width to period) that are proportional to acceleration. The duty
cycle outputs can be directly interfaced to a microprocessor.
The typical noise floor is 0.2 mg/ Hz allowing signals below 1 milli-g to be resolved at 1 Hz bandwidth.
The MXD2125G/H/M/N is packaged in a hermetically sealed LCC surface mount package (5 mm x 5 mm x 2 mm height)
and is operational over a -40°C to 105°C(M/N) and 0°C to 70°C(G/H) temperature range.
Please send any comments to: firstname.lastname@example.org